AbbA Ultra

According to the label, under what condition regarding previous treatments should AbbA Ultra NOT be applied?

• If it has been more than 10 days since the last treatment
• If an alternative miticide with a different mode of action has been used ✓
• If the temperature is above 90 degrees
• If the previous application was via aerial method

Answer: The label states do not apply if an alternative miticide with a different mode of action has been used.

🔗 Source

What is the mandatory Restricted-Entry Interval (REI) for this product?

• 6 hours
• 12 hours ✓
• 24 hours
• 48 hours

Answer: Users must adhere to a restricted-entry interval (REI) of 12 hours.

🔗 Source

When performing a ground application of AbbA Ultra, what is the required minimum amount of water per acre?

• 10 gallons
• 20 gallons ✓
• 40 gallons
• 60 gallons

Answer: For ground applications, the label requires a minimum of 20 gallons of water per acre.

🔗 Source

Which of the following is a strict application restriction for AbbA Ultra?

• Do not apply through irrigation systems ✓
• Do not apply during daylight hours
• Do not apply via aerial methods
• Do not apply more than 5 times per season

Answer: The label explicitly states: 'It is critical to avoid application through irrigation systems.'

🔗 Source

What is the maximum number of applications allowed per cropping season for AbbA Ultra?

• 1 application
• 2 applications ✓
• 3 applications
• Unlimited applications

Answer: The restrictions state: 'Do not apply more than 2 applications per cropping season.'

🔗 Source

What is the correct application rate and water volume for an aerial application of AbbA Ultra?

• 4-8 fl oz per acre in 20 gallons of water
• 6-8 fl oz per acre in 10 gallons of water ✓
• 6-8 fl oz per acre in 20 gallons of water
• 4-8 fl oz per acre in 10 gallons of water

Answer: For aerial applications, the label specifies 6-8 fl oz per acre in a minimum of 10 gallons of water per acre.

🔗 Source

Regarding environmental safety and drift, what must the applicator avoid?

• Drift onto blooming crops or weeds ✓
• Application during windy conditions only
• Application near residential areas
• Application on soil with high moisture

Answer: The label instructs to prevent drift onto blooming crops or weeds because the product is highly toxic to bees.

🔗 Source

What is the specific target pest and crop combination for which AbbA Ultra is intended under this SLN label?

• Spider mites on alfalfa grown for seed ✓
• Spider mites on alfalfa grown for forage
• Aphids on alfalfa grown for seed
• Mites on clover grown for seed

Answer: The label states the product is intended for use on alfalfa grown for seed to control spider mites.

🔗 Source