Amid Thin W

When mixing Amid Thin W, which of these is mentioned as a compatible product?

• Carbaryl or Ethrel ✓
• Malathion or Sevin
• Glyphosate or Roundup
• Copper sulfate

Answer: The mixing notes state it can be mixed with compatible products like Carbaryl or Ethrel.

🔗 Source

Which of the following is a required piece of Personal Protective Equipment (PPE) for handling this product?

• Chemical-resistant gloves ✓
• N95 respiratory mask
• Goggles and face shield
• Waterproof apron

Answer: The PPE section specifically lists chemical-resistant gloves as a requirement.

🔗 Source

What is the Re-entry Interval (REI) for this product?

• 48 hours ✓
• 24 hours
• 12 hours
• 72 hours

Answer: The label explicitly lists the rei_hours as 48.

🔗 Source

What risk is associated with applying the product too late (later than the petal fall stage) for certain varieties?

• Pygmy fruit development ✓
• Leaf drop
• Root rot
• Fruit discoloration

Answer: The restrictions note that for certain varieties, do not apply later than petal fall to avoid risks like pygmy fruit development.

🔗 Source

What is the primary purpose of using Amid Thin W in an orchard?

• To thin apples and pears to increase fruit size and quality ✓
• To control infestations of apple worms and pear pests
• To act as a fungicide for pear tree diseases
• To increase the growth rate of tree leaves

Answer: The label describes Amid Thin W as a plant growth regulator used for thinning apples and pears to increase fruit size and quality.

🔗 Source

In what setting is Amid Thin W intended to be applied?

• Outdoor apple and pear orchards ✓
• Indoor greenhouse environments
• Residential lawns and gardens
• Hydroponic fruit systems

Answer: The application details specify the location as 'Outdoor' and the site as 'Apple and Pear Orchards.'

🔗 Source

According to the label, what is the maximum amount of Amid Thin W allowed per acre per single application?

• 20.9 oz. (0.11 lbs. active equivalent) ✓
• 62.7 oz. (0.33 lbs. active equivalent)
• 300 oz. per acre
• 50 ppm per acre

Answer: The restrictions state: 'Do not exceed 20.9 oz. Amid Thin W (0.11 lbs. active equivalent) per acre per application.'

🔗 Source

Under what wind speed condition should application be avoided?

• When wind speeds exceed 10 mph ✓
• When wind speeds are below 5 mph
• When wind speeds are between 15 and 20 mph
• Wind speed does not affect application

Answer: The timing/weather section states: 'Do not apply if winds exceed 10 mph.'

🔗 Source