Practice 15 CB D Foam II exam questions with instant feedback and cited explanations.
Where is the approved site for termite application according to the label?
Answer: The label specifies application in localized above-ground areas, galleries, or voids in termite-damaged wood.
What is the expansion rate of CB D Foam II?
Answer: The label notes that this particular product has an expansion rate of approximately 60:1.
When treating termites, what volume of product is required to produce 1 gallon of foam?
Answer: The label notes that 2 fl. oz of product will produce 1 gallon of foam.
According to the restrictions, which of the following surfaces should you NOT apply this product to?
Answer: The label states: 'Do not apply to plastic, painted or varnished surfaces'.
Which of the following is a target pest for CB D Foam II when applied directly into gallery entrance holes?
Answer: The label specifies applying the product directly into gallery entrance holes for Carpenter Bees.
Regarding environmental and temperature conditions, what may occur if the product is exposed to temperatures above 130°F?
Answer: The label states exposure to temperatures above 130°F may cause bursting.
What Personal Protective Equipment (PPE) guidance is provided on the label?
Answer: The PPE section states: Avoid contact with skin, eyes, or clothing.
Which of the following pests is specifically listed as a target for CB D Foam II?
Answer: The label explicitly lists Carpenter Ants as a target pest.