CORAGEN INSECT CONTROL 2026 03 22

What is the Re-entry Interval (REI) for this product?

• 4 hours ✓
• 12 hours
• 24 hours
• 48 hours

Answer: The label specifies a '4-hour REI'.

What is the maximum allowed application of Coragen insect control per acre per crop per season?

• 15.4 fl. oz./A ✓
• 5.0 fl. oz./A
• 7.5 fl. oz./A
• 2.0 lb. active ingredient

Answer: The restrictions state: 'Do not apply more than 15.4 fl. oz./A Coragen insect control... per acre per crop per season.'

Which pest is controlled at a rate of 2.0–5.0 fl. oz./A via Foliar Application?

• hornworms ✓
• silverleaf whiteflies (nymphs)
• Colorado potato beetle
• European corn borer

Answer: The label states that for Foliar Application, hornworms are controlled at a rate of 2.0–5.0 fl. oz./A.

Regarding application timing, when should applications be made for best results?

• At or before egg deposition ✓
• After the insect reaches adult stage
• Only when populations are at peak damage
• After the spray has fully dried

Answer: The label states: 'For best results, applications should be timed at or before egg deposition.'

Which of the following application sites is NOT permitted for Avaunt insecticide?

• Soil At-Planting ✓
• Foliar Application
• Drip Chemigation
• None of the above

Answer: The label explicitly states that Avaunt insecticide is not labeled for soil at-plant applications or drip chemigation.

According to the PPE requirements, what must a technician wear during application?

• Long-sleeved shirt, long pants, shoes plus socks ✓
• Chemical resistant gloves and goggles
• Respirator and face shield
• Short-sleeved shirt and boots

Answer: The label lists the required PPE as: 'Long-sleeved shirt and long pants, shoes plus socks'.

Which adjuvant type is specifically NOT recommended for use with Coragen insect control?

• Sticker-type spray adjuvants ✓
• Surfactants
• Emulsifiers
• Oil-based spreaders

Answer: The restrictions state: 'Sticker-type spray adjuvants are not recommended with Coragen insect control.'

When targeting leafminers (larvae) and silverleaf whiteflies (nymphs) via Foliar Application, what is the required application rate?

• 5.0–7.5 fl. oz./A ✓
• 2.0–5.0 fl. oz./A
• 3.5–5.0 fl. oz./A
• 3.5 fl. oz./A

Answer: The label specifies a rate of 5.0–7.5 fl. oz./A for leafminers (larvae) and silverleaf whiteflies (nymphs) during Foliar Application.