D Force 2026 03 22

According to the label, how should a technician handle contaminated clothing after use?

• Remove contaminated clothing and wash before reuse ✓
• Discard contaminated clothing immediately
• Wash clothing with water only
• Dry clothing in a high-heat dryer before washing

Answer: The PPE section states to remove contaminated clothing and wash before reuse.

🔗 Source

What is the required application rate for spot treatments in Food/Feed Handling Establishments?

• 1 second spray per spot ✓
• 2 seconds spray per spot
• Apply until the surface is wet
• Dilute 1 ounce per gallon

Answer: The label specifies a rate of 1 second spray per spot for Food/Feed Handling Establishments.

🔗 Source

When performing indoor treatments in a home, where should the technician focus application to target insect harborage?

• Cracks, crevices, and hidden areas around sinks and storage ✓
• Only on open floor surfaces
• Directly onto food preparation counters
• Only on window sills and door frames

Answer: The label instructs to apply thoroughly to all insect harborage areas, especially in cracks and crevices and hidden areas around sinks and storage.

🔗 Source

Which of the following is a prohibited application site for this product?

• Directly to any body of water ✓
• Cracks and crevices in a kitchen
• Behind baseboards in a home
• Underneath cupboards and cabinets

Answer: The restrictions explicitly state: Do not apply directly to any body of water.

🔗 Source

When applying D Force 2026 03 22 in a home setting, what should you do if the spray contacts a food or feed surface?

• Clean the surface with soap and water ✓
• Apply a second layer of product to neutralize
• Leave the surface to air dry completely
• Wipe the surface with a dry cloth only

Answer: The label states that if spray contacts food/feed surfaces in the home, clean those surfaces with soap and water.

🔗 Source

Where is D Force 2026 03 22 specifically authorized for use within Federally Inspected Meat and Poultry Plants?

• As a crack and crevice treatment ✓
• As a general surface application
• As a direct food spray
• As a liquid soak for equipment

Answer: The label states this product is for use in Federally Inspected Meat and Poultry Plants as a crack and crevice treatment.

🔗 Source

What must be done to food processing surfaces in a food/feed handling establishment after application?

• Wash surfaces thoroughly before use ✓
• Leave them as is if they were covered
• Apply a neutralizer spray
• No action is required if the facility is closed

Answer: The label states all food processing surfaces should be covered during treatment or thoroughly washed before use.

🔗 Source

In a Food/Feed Handling Establishment, when are general surface applications permitted?

• Only when the facility is not in operation ✓
• At any time during facility operation
• Only during night shifts
• Only when food is being actively prepared

Answer: General surface applications must be used only when the facility is not in operation.

🔗 Source