Duracor Herbicide

When applying Duracor Herbicide at a rate of 20 fl oz/A, what is one of the listed amounts to be used per 3 gallons of water?

• 1.2 fl oz
• 3.0 fl oz ✓
• 0.4 fl oz
• 1.8 fl oz

Answer: The mixing notes state that at a 20 fl oz/A rate, 3.0 fl oz can be used per 3 gallons of water to achieve a 0.78% finished strength.

🔗 Source

What must a technician do before tank mixing any pesticide product with Duracor Herbicide?

• Test the pH of the water
• Refer to www.DuraCorTankmix.com for specific product information ✓
• Add a surfactant to the mixture
• Wait 24 hours after mixing

Answer: The restrictions state: 'DO NOT TANK MIX ANY PESTICIDE PRODUCT WITH THIS PRODUCT without first referring to the following website for the specific product: www.DuraCorTankmix.com.'

🔗 Source

When tank mixing, which of the following is a requirement for the products used?

• They must be liquid-only formulations
• They must be registered for the intended use site, application method, and timing ✓
• They must be applied at the same time of day
• They must contain the same active ingredient

Answer: The restrictions state that tank mix products must be registered for the intended use site, application method, and timing.

🔗 Source

Under which environmental conditions might the herbicide activity be enhanced?

• High rainfall and high humidity
• Adverse conditions such as high temperature, low relative humidity, or drought ✓
• Low temperatures and heavy frost
• Overcast skies and high soil moisture

Answer: The timing/weather section notes the product can enhance activity under adverse environmental conditions like high temperature, low relative humidity, and drought.

🔗 Source

At a 100 fl oz/A rate, what is the finished strength if 0.4 fl oz is used per 3 gallons of water?

• 0.10% ✓
• 0.13%
• 0.26%
• 0.31%

Answer: The mixing notes state that at a 100 fl oz/A rate, using 0.4 fl oz per 3 gallons of water results in a 0.10% finished strength.

🔗 Source

According to the label, what are the target pests for Duracor Herbicide?

• Insects and mites
• Weeds and brush ✓
• Fungi and mold
• Rodents and grasses

Answer: The applications section identifies the target pests as weeds and brush.

🔗 Source

If applying Duracor Herbicide at a rate of 16 fl oz/A, how much product should be used per 1000 sq. ft?

• 0.28
• 0.37 ✓
• 0.46
• 0.50

Answer: The mixing notes specify that at a 16 fl oz/acre rate, the amount is 0.37 per 1000 sq. ft.

🔗 Source

Which application system is specifically prohibited for use with this product?

• High-pressure sprayers
• Mist blower systems that deliver very fine spray droplets ✓
• Drip irrigation systems
• Handheld pump sprayers

Answer: The restrictions section states: 'Do not apply this product with mist blower systems that deliver very fine spray droplets.'

🔗 Source