ELEVEST INSECT CONTROL es 2026 03 22

During spray preparation, what is the required method for ensuring the insecticide is fully dispersed in the tank?

• Air agitation only.
• Mechanical or hydraulic means. ✓
• Manual stirring only.
• High-pressure air injection.

Answer: Use mechanical or hydraulic means; do not use air agitation.

🔗 Source

According to the label, what must be done once the insecticide is dispersed in the spray tank?

• Stop agitation to prevent foaming.
• Add all additives immediately.
• Continue agitation. ✓
• Increase air agitation.

Answer: Mix thoroughly to fully disperse the insecticide, once dispersed continued agitation is required.

🔗 Source

When mixing at-plant applications with fertilizer, when should micronutrients or soil amendments be added?

• Before the liquid fertilizer is added to the tank.
• At the same time as the ELEVEST® insect control.
• After the ELEVEST® insect control is thoroughly mixed with the carrier. ✓
• After the entire tank is filled and agitated.

Answer: Add any other additives (micronutrients, soil amendments, etc.) to the tank after the ELEVEST® insect control is thoroughly mixed with the carrier.

🔗 Source

Under what condition is mixing ELEVEST® insect control with another product prohibited?

• If the other product contains a label prohibition against such mixing. ✓
• If the other product is a liquid fertilizer.
• If the other product is a soil amendment.
• If the other product requires air agitation.

Answer: This product cannot be mixed with any product containing a label prohibition against such mixing.

🔗 Source

What is the requirement for Personal Protective Equipment (PPE) when using this product?

• Use the PPE specified on the ELEVEST® label only.
• Use the most restrictive PPE of the products to be tested. ✓
• Standard chemical-resistant gloves and goggles.
• PPE is not required for this product.

Answer: PPE: Using the most restrictive PPE of the products to be tested

🔗 Source

When performing at-plant applications with fertilizer, in what order should the ingredients be added to the tank?

• Add fertilizer, then ELEVEST® insect control, then remaining fertilizer or water, followed by additives. ✓
• Add water, then ELEVEST® insect control, then fertilizer, then additives.
• Add ELEVEST® insect control, then water, then fertilizer, then additives.
• Add additives, then fertilizer, then ELEVEST® insect control, then water.

Answer: At-plant Applications with Fertilizer: Fill the tank 1/3 to ½ full with liquid fertilizer or water and begin spray tank agitation. Add the proper amount of ELEVEST® insect control, and then add the rest of the fertilizer or water. Add any other additives (micronutrients, soil amendments, etc.) to the tank after the ELEVEST® insect control is thoroughly mixed with the carrier.

🔗 Source

What restriction is placed on the application of this product regarding dosage?

• Do not exceed labeled dosage rates. ✓
• Only apply at half the labeled dosage rate.
• Apply at twice the labeled dosage rate for at-plant applications.
• Dosage rates must be adjusted based on air agitation.

Answer: Do not exceed labeled dosage rates.

🔗 Source

When mixing ELEVEST® insect control with water for spray preparation, how much water should be used to fill the tank initially?

• 1/3 to 1/2 full
• 1/2 to 3/4 full
• 1/4 to 1/2 full ✓
• Full tank capacity

Answer: Spray Preparation: Fill spray tank 1/4 to 1/2 full of water.

🔗 Source