PT Alpine Pressurized Fly Bait

What weather condition prohibits outdoor applications of this product?

• High winds
• Extreme heat
• Rain ✓
• Snow

Answer: The timing/weather section states: DO NOT make outdoor applications during rain.

🔗 Source

Which of the following is a prohibited location for bed bug treatment using this product?

• Clothes closets
• Patient rooms of hospitals and nursing homes ✓
• Underneath flat surfaces
• Behind headboards

Answer: The label states: DO NOT use in patient rooms of hospitals and nursing homes for treatment of bed bugs.

🔗 Source

When applying the product to cracks and crevices using the injector tip, what speed should the technician move the tip?

• 1 ft/sec
• 5 ft/sec
• 3 ft/sec ✓
• 10 ft/sec

Answer: The label instructs to move the injector tip along cracks while treating at the rate of 3 ft/sec.

🔗 Source

When performing a spot treatment, what is the maximum allowable area for an individual spot?

• 20% of the surface area or 2 ft2 ✓
• 10% of the surface area or 5 ft2
• 50% of the surface area or 10 ft2
• 2 ft2 regardless of surface area percentage

Answer: The label states to limit individual spot treatments to an area no larger than 20% of the surface area and that no individual spot treatment shall exceed 2 ft2.

🔗 Source

What is the application rate for treating closed voids?

• 1 sec/10 ft2
• 3 to 5 sec/3 ft3 ✓
• 1 sec/ft2
• 10 sec/room

Answer: For closed voids, the label specifies a rate of 3 to 5 sec/3 ft3.

🔗 Source

When treating for fleas, lice, and ticks on pet bedding and floor coverings, what precaution should be taken?

• Always treat the entire area first.
• Treat a small inconspicuous area before treating the entire area.
• Avoid contact with antique finishes.
• Both B and C are correct. ✓

Answer: The label notes to treat a small inconspicuous area first and to avoid contact with antique finishes for this target pest.

🔗 Source

In a commercial area, what is the maximum application rate when treating corners of a room, behind or under furniture?

• 10 sec/room
• 1 sec/10 ft2
• 10 sec/100 ft2 ✓
• 5 sec/3 ft3

Answer: For commercial areas, the rate for corners/under furniture must not exceed 10 sec/100 ft2.

🔗 Source

When treating for bed bugs, what is the restriction regarding mattresses?

• Do not make surface applications to mattresses or bedding. ✓
• Do not treat the seams or folds of a mattress.
• Mattresses must be treated from the top surface only.
• Bedding should be treated before being removed.

Answer: The label explicitly states: DO NOT make surface applications to mattresses or bedding.

🔗 Source