Section Three

What is the herbicide group classification for the active ingredient in Section Three?

• Group 2
• Group 1 ✓
• Group 3
• Group 4

Answer: Its active ingredient is Clethodim, which belongs to the Group 1 herbicide class.

🔗 Source

According to the label, what is the maximum wind speed allowed at the application site for using this product?

• 5 miles per hour
• 10 miles per hour ✓
• 15 miles per hour
• 20 miles per hour

Answer: Do not apply when wind speeds exceed 10 miles per hour at the application site.

🔗 Source

For which of the following crops is application of Section Three explicitly restricted if specific directions are not provided?

• Alfalfa
• Barley
• Corn
• Crops being grown for seed ✓

Answer: Do not apply this product to crops being grown for seed unless specific directions are provided.

🔗 Source

When tank-mixing Section Three with other labeled herbicides, what is the correct order for adding formulations?

• Dry formulations, then water-soluble liquids, then emulsifiable concentrates
• Water-soluble liquids, then dry formulations, then emulsifiable concentrates and then solutions ✓
• Emulsifiable concentrates, then solutions, then water-soluble liquids
• Solutions, then emulsifiable concentrates, then dry formulations

Answer: When tank-mixing with other labeled herbicides, add water-soluble liquids first, followed by dry formulations, emulsifiable concentrates and then solutions.

🔗 Source

Which of the following is a listed restriction regarding specific crop types for Section Three?

• Do not apply to onions, garlic, shallots or other non-bearing food crops ✓
• Do not apply to corn or barley
• Do not apply to alfalfa if wind is high
• Do not apply to any cereal grains

Answer: Do not apply to onions, garlic, shallots or other non-bearing food crops.

🔗 Source

What is the correct sequence for mixing Section Three in a sprayer tank?

• Fill tank with water, add herbicide, add adjuvants, fill to desired level with water
• Fill tank with 2/3 to 3/4 water, add herbicide, add adjuvants, fill to desired level with water
• Fill tank with 2/3 to 2/3 of desired clean water with liquid herbicide, add adjuvants, fill to desired level with water ✓
• Fill tank with herbicide, add water, add adjuvants, agitate until rising

Answer: Fill sprayer tank with 2/3 to 2/3 of desired clean water with liquid herbicide. Adding the correct amount of herbicide, making sure that agitation makes a rising mixture. ... Add any required adjuvants... Fill sprayer tank to desired level with water.

🔗 Source

Which of the following is a required piece of Personal Protective Equipment (PPE) for applicators and handlers of Section Three?

• Nitrile rubber 14 mil gloves ✓
• Chemical-resistant apron
• Respirator
• Face shield

Answer: Applicators and other handlers must wear: long-sleeved shirt and long pants, chemical-resistant gloves made of any waterproof material (nitrile rubber 14 mil, butyl rubber 14 mils, viton 14 mils, and/or barrier laminate), shoe soles and socks, and protective eyewear.

🔗 Source

Under what weather condition should an applicator avoid using Section Three to reduce the effects of evaporation?

• High wind speeds
• Temperature inversions
• High heat and dry conditions ✓
• Wind speeds exceeding 10 miles per hour

Answer: Avoid applying during high heat and dry conditions; use larger droplets to reduce effects of evaporation.

🔗 Source