Termidor 80 WG Termiticide Insecticide archived 2024 04 2026 03 22

When treating foundations deeper than 4 feet outdoors, what is the required application rate?

• 1.0 to 1.5 gallons per 10 square feet
• 2 gallons per 10 linear feet per foot of depth ✓
• 0.06% finished dilution per 10 linear feet
• 4 gallons per 100 gallons of water

Answer: For foundations deeper than 4 feet, the rate is 2 gallons per 10 linear feet per foot of depth.

🔗 Source

If the soil will not accept the labeled volumes, what alternative application method is permitted?

• Apply at a 0.06% concentration using double the volume.
• Apply at a 0.25% concentration using half the volume of finished dilution. ✓
• Apply at a 0.125% concentration using triple the volume.
• Apply only to the surface without trenching.

Answer: The notes state that if soil will not accept labeled volumes, twice the concentration (0.25%) may be applied in half the volume of finished dilution.

🔗 Source

To achieve a 0.125% finished strength, how much Termidor 80 WG should be mixed with 67 gallons of water?

• 2 units
• 4 units ✓
• 6 units
• 8 units

Answer: The mixing instructions state that 4 units of product in 67 gallons of water results in a 0.125% finished strength.

🔗 Source

According to the label restrictions, what is the minimum finished dilution concentration allowed for horizontal and vertical treatments?

• 0.03%
• 0.06% ✓
• 0.09%
• 0.125%

Answer: The restrictions state DO NOT apply at a LOWER dosage and/or concentration than 0.06%, 0.09%, or 0.125%.

🔗 Source

Which of the following pests is NOT listed as a target pest for Termidor 80 WG?

• Carpenter ants
• Drywood termites
• Bed bugs ✓
• Borers

Answer: The label lists subterranean, arboreal, drywood, and dampwood termites, carpenter ants, beetles, and borers, but does not mention bed bugs.

🔗 Source

When applying Termidor 80 WG to horizontal treated zones beneath a concrete slab on ground, what nozzle pressure should be used?

• Exactly 25 PSI
• No more than 10 PSI
• 25 PSI or less ✓
• At least 50 PSI

Answer: The label specifies using a coarse application nozzle with a nozzle pressure of 25 PSI or less for horizontal treated zones.

🔗 Source

Where can Termidor 80 WG be applied according to the 'location' descriptions for concrete slab horizontal treated zones?

• Outdoor only
• Indoor only
• Both indoor and outdoor ✓
• Only in basements

Answer: The label lists the location for Concrete Slab on Ground or in Basements - Horizontal Treated Zones as 'Both'.

🔗 Source

What is a specific restriction regarding the treatment of footings?

• Do not treat the soil above the footing.
• Do not treat a structure below the bottom of the footing. ✓
• Do not treat footings deeper than 4 feet.
• Do not treat footings with a concentration higher than 0.125%.

Answer: The label explicitly states: 'DO NOT treat a structure below the bottom of the footing.'

🔗 Source