Zenivex E20

In which of these settings is application of Zenivex E20 prohibited?

• In a library where occupants are present. ✓
• In a closet for general pest control.
• In a bedroom for bed bug control.
• In a kitchen for cockroach control.

Answer: The label states: 'Do not apply in institutions (including libraries, sports facilities, etc.) in the immediate area where occupants are present.'

🔗 Source

Which of the following pests is NOT listed as a target pest for Zenivex E20?

• Scorpions
• Bed Bugs
• Termites ✓
• Wasps

Answer: Termites are not mentioned in the provided list of target pests.

🔗 Source

When performing a Broadcast (General Surface) treatment for general pests, what is the required application rate?

• 1 fl oz per gallon of water
• 2 fl oz per gallon of water ✓
• 4 fl oz per gallon of water
• 0.25 fl oz per gallon of water

Answer: The label specifies a rate of 2 fl oz per gallon of water for general surface treatments.

🔗 Source

When mixing the product for general pests, what is the correct procedure for best results?

• Fill the sprayer completely with water first, then add the product.
• Mix the product with a small amount of water, then fill to the required amount of water. ✓
• Add the product to a dry sprayer and then add water.
• Mix the product with oil before adding to water.

Answer: For best results, partially fill the sprayer with water, add the labeled amount of product, and then fill to the required amount of water.

🔗 Source

When treating Bed Bugs, how should the mattress and box spring be treated?

• Treat the entire surface of the mattress and box spring.
• Saturate the mattress and box spring completely.
• Apply to seams, edges, and tufts only; do not treat the entire surface. ✓
• Apply to the entire surface using a high-pressure spray.

Answer: For Bed Bugs, the label states to apply to seams, edges, and tufts only and not to treat the entire surface.

🔗 Source

Which of the following is a specific restriction regarding Bed Bug treatments?

• Do not apply to the bed frame.
• Do not apply to the baseboards.
• Do not apply product to bedding. ✓
• Do not use a coarse, low-pressure spray.

Answer: The label explicitly states: 'Do not apply product to bedding.'

🔗 Source

Under what condition can people re-enter the treated area?

• Immediately after application.
• After 24 hours have passed.
• Once the spray has dried. ✓
• Only after the technician has left the building.

Answer: The re-entry instruction states: 'Do not enter or allow others to enter until spray has dried.'

🔗 Source

According to the label, where is Zenivex E20 permitted to be applied?

• Indoor only ✓
• Outdoor only
• Both Indoor and Outdoor
• Only in unoccupied patient rooms

Answer: All application sites listed in the label facts are categorized under 'Indoor'.

🔗 Source